Sony DCR-HC19E - Remote Commander; Searching Quickly for a Desired Scene (Zero Set Memory)

32
DCR-HC32/HC42 2-584-906-11(1)
Remote Commander
Remove the insulation sheet before using
the Remote Commander.
Insulation sheet
6
1
q;
2
3
4
5
7
8
9
 PHOTO (p. 22)
The on-screen image when you press this
button will be recorded as a still image.
 SEARCH M. (p. 31)
  
 Video control buttons (Rewind,
Playback, Fast-forward, Pause, Stop,
Slow) (p. 23)
 ZERO SET MEMORY
 Transmitter
 REC START/STOP (p. 22)
 Power zoom (p. 24)
 DISPLAY (p. 16)
 Memory control buttons (Index, –/+,
Memory playback) (p. 23)
• Aim the Remote Commander towards the
remote sensor to operate your camcorder (p.
26).
• To change the battery, see page 114.
Searching quickly for a desired
scene (Zero set memory)
1 During playback, press ZERO
SET MEMORY

at a point you
want to locate later on.
The tape counter is reset to “0:00:00”
and appears on the screen.
0: 00: 0 060 min
P-MENU
If the tape counter is not displayed,
press DISPLAY

.
2 Press STOP

when you want to
stop playback.
3 Press REW

.
The tape stops automatically when the
tape counter reaches “0:00:00.”
4 Press PLAY

.
Playback starts from the point
designated “0:00:00” on the tape
counter.
• There may be a discrepancy of several seconds
between the time code and the tape counter.
• Zero set memory will not function correctly
if there is a blank section between recorded
sections on the tape.
To cancel the operation
Press ZERO SET MEMORY

again.