142
Recording superimposed images on a “Memory Stick” as a still
image
Before operation
Insert a “Memory Stick” recorded still images into your camcorder.
(1) Set the POWER switch to MEMORY/NETWORK (DCR-TRV50 only). Make
sure that the LOCK switch is set to the left (unlock) position.
(2) Press FN and select PAGE2.
(3) Press MEM MIX. The last recorded or last composed image appears on the
lower part of the screen as a thumbnail image.
(4) Press –/+ on the right lower corner of the screen to select the still image which
you want to superimpose.
–: To see the previous image
+: To see the next image
(5) Press a desired mode. The still image is superimposed on the moving picture.
(6) Press –/+ on the left lower corner of the screen to adjust the effect, then press
OK to return to PAGE2.
M. CHROM: Blue chroma key (only blue background portion) to extract a
still image and superimpose it on a moving image
M. LUMI: Brightness level used when extracting a still image and
superimposing it on a moving image
C. CHROM: Blue chroma key (only blue background portion) to extract a
moving picture and superimpose it on a still image
The fewer bars there are on the screen, the stronger the effect.
(7) Press EXIT to return to FN.
(8) Press PHOTO deeper to start recording.
The image displayed on the screen will be recorded on a “Memory Stick.”
Recording is complete when the bar scroll indicator disappears.
Superimposing a still image in the “Memory Stick” on an image
– MEMORY MIX
To Next Page
Loading...
Need help?
General