108
Selecting the image size
You can select 320 × 240 or 160 × 112 of the moving picture size.
The default setting is 320 × 240.
(1) Set the POWER switch to MEMORY. Make sure that the LOCK switch is set to
the left (unlock) position.
(2) Press MENU to display the menu.
(3) Turn the SEL/PUSH EXEC dial to select
, then press the dial.
(4) Turn the SEL/PUSH EXEC dial to select MOVIE SET (moving picture), then
press the dial.
(5) Turn the SEL/PUSH EXEC dial to select IMAGESIZE, then press the dial.
(6) Turn the SEL/PUSH EXEC dial to select the desired image size, then press the
dial.
The indicator changes as follows:
320 160
Using a “Memory Stick” – introduction
To Next Page
Loading...
