85
Editing
You can record an audio sound to add to the original sound on a tape by connecting
audio equipment or a microphone. If you connect the audio equipment, you can add
sound to your recorded tape by specifying starting and ending points. The original
sound will not be erased.
Select one of the following connections to add an audio sound.
Connecting the microphone with the MIC jack
You can check the recorded picture and sound by connecting your camcorder to a TV
with the A/V connecting cable.
The recorded sound is not output from a speaker. Check the sound by using the TV or
headphones.
Connecting the microphone with the intelligent accessory shoe
Audio dubbing
Intelligent Accessory Shoe
Microphone (optional)
: Signal flow
MIC
(PLUG IN
POWER)
Microphone (optional)
To Next Page
Loading...
