28
While using the Super NightShot function
The shutter speed is automatically adjusted depending on the brightness. At that time,
the moving picture may be slow down.
While using the Super NightShot function, you cannot use the following
functions:
– Exposure
– PROGRAM AE
– Fader
– Digital effect
– White balance
While in MEMORY mode (DCR-TRV17 only)
You cannot use the Super NightShot function.
NightShot Light
NightShot Light rays are infrared and so are invisible. The maximum shooting distance
using the NightShot Light is about 3 m (10 feet).
Self-timer recording
Recording with the self-timer starts in 10 seconds automatically. You can also use the
Remote Commander for this operation.
(1) Press MENU to display the menu settings in the standby mode.
(2) Turn the SEL/PUSH EXEC dial to select
, then press the dial.
(3) Turn the SEL/PUSH EXEC dial to select SELFTIMER, then press the dial.
(4) Turn the SEL/PUSH EXEC dial to select ON, then press the dial.
(5) Press MENU to make the menu settings disappear.
(6) Press START/STOP.
Self-timer starts counting down from 10 with a beep sound. In the last two
seconds of the countdown, the beep sound gets faster, then recording starts
automatically. To stop recording, press START/STOP again.
Recording a picture
3
CAMERA SET
OFF
ON
SELFT IMER
DZOOM
16
:
9
W
IDE
STEADYSHOT
N
.
S
.
LIGHT
FRAME REC
RETURN
[
MENU
]
:
END
INT
.
REC
1,5 MENU
START/STOP
6 START/STOP
To Next Page
Loading...
Need help?
General