128
To stop or end copying
Press MENU.
When the memory of the “Memory Stick” is full
“MEMORY FULL” appears on the screen, and the copying stops. Insert another
“Memory Stick” and repeat the procedure from step 2.
When the access lamp is lit or flashing
Do not shake or strike your camcorder. As well do not turn the power off, eject a
“Memory Stick” or remove the battery pack. Otherwise, the image data breakdown may
occur.
If the write-protect tab on the “Memory Stick” is set to LOCK
“NOT READY” appears when you select the item in the menu settings.
When you change “Memory Stick”s in the middle of copying
Your camcorder resumes copying from the last image recorded on the previous
“Memory Stick.”
Copying still images from a tape – Photo save
To Next Page
Loading...
Need help?
General