Sony DCR-TRV17 Operating Instructions (primary manual) - Page 71

71
Editing
Dubbing only desired scenes – Digital program editing
(2)Setting the modes to cancel recording pause on the VCR
1 Turn the SEL/PUSH EXEC dial to select PAUSEMODE, then press the dial.
2 Turn the SEL/PUSH EXEC dial to select the mode to cancel recording pause
on the VCR, then press the dial.
Buttons for canceling recording pause on the VCR
The buttons vary depending on your VCR. To cancel recording pause:
– Select PAUSE if the button to cancel recording pause is X.
– Select REC if the button to cancel recording pause is z.
– Select PB if the button to cancel recording pause is N.
(3) Setting your camcorder and the VCR to face each other
Locate the infrared rays emitter of your camcorder and face it towards the remote
sensor of the VCR.
Set the devices about 30 cm (12 in.) apart, and remove any obstacles between the
devices.
12
OTHERS
ED I TSET
CONTROL
ADJ TEST
” CUT - IN ”
”
CUT - OUT ”
IR SETUP
PAUSEMODE
IR TEST
PAUSE
REC
PB
RETURN
[
MENU
] :
END
OTHERS
ED I TSET
CONTROL
ADJ TEST
” CUT - IN ”
”
CUT - OUT ”
IR SETUP
PAUSEMODE
IR TEST
PAUSE
RETURN
[
MENU
] :
END
Remote sensor
Infrared ray emitter
A/V connecting cable