146
Viewing images recorded on the “Memory Stick”
(1) Insert the “Memory Stick” into your camcorder.
(2) Connect the AC Adaptor, then set the POWER switch to MEMORY.
(3) Connect the
(USB) jack on your camcorder to the USB port on the computer
using the supplied USB cable.
The USB MODE indicator appears on the LCD screen of your camcorder. The
computer recognizes your camcorder, and the Add Hardware Wizard starts.
(4) Follow the on-screen messages so that the Add Hardware Wizard recognizes
that the USB drivers have been installed. The Add Hardware Wizard starts
two times because two different USB drivers are installed. Be sure to allow the
installation to complete without interrupting it.
You cannot install the USB driver if the “Memory Stick” is not in your camcorder
Be sure to insert the “Memory Stick” into your camcorder before installing the USB
driver.
Connecting your camcorder to a computer using the USB cable
(For Windows users)
USB port
USB cable (supplied)
(USB) jack
To Next Page
Loading...
Need help?
General