Sony DFS-700 - Changing Direct Pattern Assignments

Chapter 4 Advanced Operations
4-2 Chapter 4 Advanced Operations
2 Use buttons 0 to 9 to enter the pattern number you want to assign to a
button.
For more information about pattern numbers, see the section “Effect Pattern
Image List” (page A-29).
The number you enter appears in the PATTERN NUMBER display
window.
3 Press the ENTER button.
4 While holding down the DIRECT PATTERN button, press the button
(0 to 9, or P IN P/RST) to which you want to assign the pattern.
The button you pressed lights, and the pattern number entered in step 2
is assigned to the button.
To restore the default assignments (direct pattern reinitialization)
After changing pattern assignments, you can restore the factory default
assignments shown in “Example Effects” (page 3-18).
To return all of the buttons 0 to 9 and P IN P/RST to their factory default
assignments, use the following procedure.
1 Press the SET UP button.
The setup menu appears.
2 Press the PAGE button to display page 6/8.
3 Press the F4(KEYPAD) button to set it to “ON”.
4 Press the F5(EXEC) button.
5 Press the F3(OK) button.
This returns all of the assignments to the 0 to 9 and P IN P/RST buttons
to their factory default settings.
Changing Direct Pattern Assignments