Sony DPS-R7 - Safety Warnings and Compliance; Electric Shock Prevention; FCC Compliance and Interference; Canadian Customer Safety Advice

WARNING
FOR CUSTOMERS IN THE UNITED STATES
Owner’s Record
The model and serial numbers are located on the left side.
Record these numbers in the spaces provided below.
Refer to these numbers whenever you call upon your Sony
dealer regarding this product.
Model No. DPS-R7 Serial No.
To prevent fire or shock hazard, do not
expose the unit to rain or moisture.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
This symboi! is intended to alert the
user to the presence of uninsulated
“dangerous voltage” within the prod-
uct’s enclosure that may be of suffi-
cient magnitude to constitute a risk of
electric shock to persons.
This symbol is intended to alert the
user to the presence of important
operating and maintenance (servicing)
instructions in the literature accompa-
nying the appliance.
\
For detailed safety precautions, see the leaflet
“IMPORTANT SAFEGUARDS”.
2
INFORMATION
This
equipment
generates
and
uses
radio
frequency
energy
and if not installed and used properly, that is, in strict
accordance
with
the
manufacturer’s
instructions,
may
cause
interference to radio and television reception. It has been
type
tested
and
found
to
comply
with
the
limits
for
a
Class
B
computing
device
in
accordance
with
the
specifications
in
Subpart J of Part 15 of FCC Rules, which are designed to
provide
reasonable
protection
against
such
interference
in
a
residential
installation.
However,
there
is
no
guarantee
that
interference
will
not
occur
in
a
particular
installation.
If
this
equipment does cause interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
Reorient the receiving antenna
Relocate
the
equipment
with
respect
to
the
receiver
Move the equipment away from the receiver
Plug the equipment into a different outlet so that
equipment and receiver are on different branch circuits.
If necessary, the user should consult the dealer or an
experienced radio/television technician for additional
suggestions. The user may find the following booklet
prepared by the Federal Communications Commission
helpful:
“How to Identify and Resolve Radio-TV Interference
Problems”’. This booklet is available from the U.S.
Government
Printing
Office,
Washington,
DC
20402,
Stock
No. 004-000-00345-4,
e
The
shielded
interface
cable
recommended
in
this
manual
must
be
used
with
this
equipment
in
order
to
comply
with
the
limits
for
a computing
device
pursuant
to
Subpart
J
of
Part
15
of
FCC
Rules.
FOR CUSTOMERS IN CANADA
CAUTION:
TO PREVENT ELECTRIC SHOCK, DO NOT USE THIS
POLARIZED
AC
PLUG
WITH
AN
EXTENSION
CORD,
RECEPTACLE OR OTHER OUTLET UNLESS THE
BLADES
CAN
BE
FULLY
INSERTED
TO
PREVENT
BLADE EXPOSURE.
This apparatus complies with the Class B limits for radio
noise
emissions
set
out
in
Radio
Interference
Regulations.