Sony DPS-R7 - Parameter Variation Range for LCL.MIDI Block

Parameter Variation Range for LCL.MIDI Block
Parameter variation range for input/output blocks
[ aonen Parameters hes et
range ee
level 0% — Set value
phase
control
change
data
=
normal
if
0
-
63
= inverse if 64 - 127
panpot 0% -— Set value
panpot limit min
Set value - set value for panpot limit max (*4)
panpot limit max
Set value for panpot limit min - set value (*5)
If the contro! by LCL.MIDI exceeds the upper limit of a
parameter, the upper limit value is used. On the contrary, the
lower limit value is used if it exceeds the lower limit.
(*1) Reverberation time has a different resolution according
to the algorithm and the parameter value as shown
below. Therefore, available time range differs for the set
value even in controlling with LCL. MIDI.
HLR,PLR- 0.1sec step if 0.3sec — 10.0sec
1.0sec step if 10.0sec - 99.0sec
RMR 0.04sec step if 0.12 - 4.00sec
0.4sec step if 4.00 - 39.60sec
For example, when the algorithm is HLR and the set
value is 10.0sec, the available time range lies between
set value —6.4sec and set value + 63sec.
(*2) “size” and “spread” have a different range available
according to the algorithm used.
5 6 APPENDIX B
(*3)
“release
time”
has
a
different
resolution
according
to
the
parameter
value
as
shown
below.
Therefore
available
time
range
differs
for
the
set
value
even
in
controlling
with
LCL.
MIDI.
0-500 ms 1 msstep
500 ms - 1000 ms 10 ms step
1000 ms ~ 5000 ms 100 ms step
(*4)
In
case
you
change
the
panpot
limit
min
using
LCL.
MIDI
so
that
panpot
is
equal
to
or
smaller
than
panpot
limit
min,
panpot
is
also
changed
to
the
value
of
panpot
limit
min.
(*5) In case you change the panpot limit max using LCL.
MIDI so that panpot is equal to or larger than panpot
limit max, panpot is also changed to the value of panpot
limit max.
3