DSC-W830
2-2
2-1-3. Self-diagnosis Code Table
Self-diagnosis Code
Symptom/State Correction
Repaired by:
Block
Function
Detailed
Code
C1 3 0 1
The internal memory has experienced a me-
dia error.
Turn the power off and on again.
The internal memory has experienced a for-
mat error.
Format the internal memory.
Memory card is unformatted. Format the memory card.
Memory card is broken. Insert a new memory card.
Memory card type error Insert a supported memory card.
The camera cannot read or write dataon the
memory card.
Turn the power off and on again, or taking out and inserting
the memory card several times.
C 3 2 0 1 Trouble with hardware Turn the power off and on again.
E6 1 0 0
Difficult to adjust focus
(Cannot initialize focus)
Retry turn the power on by the power switch.
E6 1 1 0
Zoom operations fault
(Cannot initialize zoom lens.)
Retry turn the power on by the power switch.
E 6 2 0 2 Abnormality of IC for steadyshot. Turn the power off and on again.
E 6 2 1 0 Lens initializing failure. Turn the power off and on again.
E 6 2 1 1 Lens overheating (PITCH). Turn the power off and on again.
E 6 2 1 2 Lens overheating (YAW). Turn the power off and on again.
E 6 2 2 0 Abnormality of thermistor. Turn the power off and on again.
E 9 1 0 1 Abnormality when flash is being charged. Checking of flash unit or replacement of flash unit. (Note)
E 9 4 0 0 Internal memory fault Turn the power off and on again.
Note: After repair, be sure to perform “3-6. PROCESS AFTER FIXING FLASH ERROR”.