HELP
DSLR-A100_L2
HELP
Sheet attachment positions and procedures of processing the flexible boards/harnesses are shown.
If the camera is started with the exterior removed
- Solder the "a" part of FP-528 Flexible Board to short-circuit.
- The FP-528 Flexible Board is short-circuited at the "b" part when it was replaced.
*Before installing the Top Cover Block, be sure to unsolder the "a" part or to cut the "b" part.
"a"
"b"
Cut
FP-528 Flexible Board
To Next Page
Loading...
