HELP
DSLR-A100_L2
Cleaning procedure of OLPF
<Preparation>
Make it to CCD Cleaning Mode of Power On/Set Up Mode by using the AC power supply.
(It comes to Mirror Up/Shutter Open)
Note: Use the AC power supply absolutely.
<Cleaning Method>
1. Soak a small amount of EE3310 (Liquid cleaner) after wrapping the cleaning cloth (J-6082-636-A) around
the cleaning jig (J-6082-635-A).
2. Surface of OLPF is cleaned. (Note that there is no wipe irregularity)
3. Power off. (It comes to Shutter Close/Mirror Down)
Note: The cleaning of the OLPF must use a specified jig. If the specified jig is not used, the low pass
filter might be damaged.
OLPF
Cleaning Jig
(J-6082-635-A)
Cleaning Cloth
(J-6082-636-A)
Cut
EE3310
To Next Page
Loading...
