Chapter 4 Editing
Chapter 4 Editing 79
Checking Edit Results—Preview
When you have set the edit points, the PREVIEW button flashes,
indicating that you can carry out a preview.
To carry out a preview, press the PREVIEW button.
The PREVIEW button changes from flashing to continuously lit, and the
preview is carried out.
At the end of the preview, the PREVIEW button flashes again.
To stop the preview
Press the STOP button.
The tape stops at the position where you pressed the button.
To return the tape to the preroll point
Press the PREROLL button.
To return the tape to the IN point or OUT point
Press the PREROLL button and the IN button or OUT button
simultaneously.
After the preview, make any necessary adjustments to the edit points, then
repeat the preview.
For details of how to modify or delete edit points, see the section “Modifying Edit
Points” (page 75).
PREVIEW button
To Next Page
Loading...
