Sony GTK-XB72 - NFC Board (Right Side)

GTK-XB72
13
Sony CONFIDENTIAL
For Authorized Servicer
2-7. NFC BOARD (RIGHT SIDE)
Note 1: When replacing the NFC board, be sure to replace the MAIN board and the
NFC board simultaneously. The NFC board cannot replace with single. Among
the repair parts, the MAIN board and the NFC board are supplied as one unit.
1 KEY (R) board cable connector
(2P) (XP12)
2 claw
3 Gradually peel off the NFC board with
a flathead screwdriver, etc.
Note 2:
The NFC board is affixed to the side panel assy
(right) with a double-side tape.
When removing the NFC board, remove slowly
so as not to damage the hook, etc. of the side
panel assy (right).
Note 3:
When installing the NFC board to the side panel assy (right), cut out the double-side tape of commercial products
to 27.0
u
18.0 mm size and paste it on the NFC board, then install the NFC board to the side panel assy (right).
Also, when installing the NFC board, firmly press the NFC board to the side panel assy (right), and paste it so that
there no gap between the NFC board and the side panel assy (right).
+RZWRLQVWDOOWKH1)&ERDUG
27.0 mm
double-side tape
(commercial products)
18.0 mm
NFC board
side panel assy (right)
(Top side inner)
Turn over.
5 NFC board
(See Note 1)
4 Remove the NFC board in
the direction of the arrow.
rear side front side
Arrow direction
NFC board
–%RWWRPYLHZ–
double-side
tape
two hooks
flathead
screwdriver, etc.
two
hooks
rear side
front side
right side
top side
side panel assy (right)
SYSSET
2019/01/1806:06:34(GMT+09:00)
jomi