Sony GTK-XB90 - NFC Board; Top Handle

GTK-XB90
12
2-10. NFC BOARD
2-11. TOP HANDLE
front side
rear side
top side
1 KEY board cable
connector (XP12)
claw
5 NFC board
top panel block
two hooks
4 Peel the NFC board off
of the adhesive sheet.
adhesive sheet
3 Gradually peel off the NFC board with
a flathead screwdriver, etc.
Note 2:
The NFC board is affixed to the top panel with
a adhesive sheet.
When removing the NFC board, remove slowly
so that you do not damage the hook, etc. of the
top panel.
top panel block
NFC board
flathead
screwdriver,
etc.
,QVWDOODWLRQGLUHFWLRQIRUWKH1)&ERDUG
front side
rear side
Arrow direction
NFC board
–%RWWRPYLHZ–
two hooks
2 claw
adhesive sheet
FFC (BT-MAIN)
1 cushion
cushion
front side
))&%70$,1VHWWLQJ
Bend.
front side
rear side
top side
top panel block
2 Move the FFC (BT-MAIN)
to the front side.
3 four screws
(M3 u 10)
3 screw
(M3 u 10)
3 screw
(M3 u 10)
3 screw
(M3 u 10)
boss
hole
4 top handle
Note:
When installing the top
handle, align the boss
and hole.
Note 1: When replacing the NFC board, be sure to replace the BT
board and the NFC board simultaneously. The NFC board
cannot replace with single.
(Among the repair parts, the BT board and the NFC board are
supplied as one unit)
SYSSET
2020/08/2022:42:53(GMT+09:00)