11
Locations and Functions of Parts
Note
Use of a D-sub case wider than 42 mm can cause interference
at connectors 2, 4, 5.
It is recommended that you use a JAE-made DA-C1-J10.
r AUX REMOTE connector (round 8-pin)
This is used to connect a sub-camera RCP for operating a
sub-camera.
s TRUNK A connector (round 12-pin)
Used to connect to the CCU connector on a video camera via
an RS-232C or RS-422A interface.
Communication with up to two channels is available.
t AUDIO OUT CH1, CH2 (audio output 1, 2) connectors
(XLR 3-pin)
Used for output of the audio signal to the AUDIO IN
connectors of the video camera.
u SPARE connector (BNC-type)
Reserved for future use.
v AC IN (AC power input) connector
Use the specified AC power cord to connect to an AC power
supply. The AC power cord can be secured to this unit, using
the plug holder (optional).
To Next Page
Loading...
