EasyManua.ls Logo

Sony HT-FS3 - Page 63

Sony HT-FS3
68 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
63
GB
Additional Information
HDMI section
Connector HDMI
TM
Connecter
Video inputs/outputs BD, DVD, SAT/CATV:
640 × 480p@60 Hz
720 × 480p@59.94/60 Hz
1280 × 720p@59.94/60 Hz
1920 × 1080i@59.94/
60 Hz
1920 × 1080p@59.94/
60 Hz
720 × 576p@50 Hz
1280 × 720p@50 Hz
1920 × 1080i@50 Hz
1920 × 1080p@50 Hz
1920 × 1080p@24 Hz
Audio inputs BD, DVD, SAT/CATV:
Linear PCM 7.1ch/
Dolby Digital/DTS
Tuner section
System PLL quartz-locked digital
synthesizer
FM tuner section
Tuning range 87.5 – 108.0 MHz
(50 kHz step)
Antenna (aerial) FM wire antenna (aerial)
Antenna (aerial) terminals 75 ohms, unbalanced
Intermediate frequency 10.7 MHz
AM tuner section
Tuning range 531 kHz – 1,602 kHz (with
the interval set at 9 kHz)
Antenna (aerial) AM loop antenna (aerial)
Intermediate frequency 450 kHz
Speakers (SS-FS3)
Speaker system Full range, Bass reflex
Speaker unit 65 mm cone type
Rated impedance 4 ohms
Dimensions (approx.) 102 mm × 163 mm × 77
mm (with foot) (w/h/d)
Mass (approx.) 0.55 kg
Subwoofer (SA-WFS3)
Speaker system Subwoofer, Bass reflex
Speaker unit 130 mm cone type
Rated impedance 2 ohms
Dimensions (approx.) 212 mm × 374 mm × 364
mm (w/h/d)
Mass (approx.) 8.9 kg
General
Power requirements 220 – 240 V AC, 50/60 Hz
Power consumption
On: 95 W
Standby mode: 0.3 W (when “CTRL: HDMI
and “S-AIR STBY” are set
to “OFF.”)
Power output
(DIGITAL MEDIA PORT) DC OUT: 5 V, 700 mA
Design and specifications are subject to change without
notice.
Standby power consumption 0.3 W.
Halogenated flame retardants are not used in the
certain printed wiring boards.
Over 85 % power efficiency of amplifier block is
achieved with the full digital amplifier, S-Master.

Table of Contents

Related product manuals