Sony icf 2010 - Memory Scan Tuning

MEMORY SCAN TUNING
Example of memorizing stations
Stations of the same band Same station with different
in a horizontal line transmitting frequencies
in a vertical line
To check the memory
After memorizing the stations, press each MEMORY PRESET key in
turn to check the stations have been memorized correctly.
To check the memory while receiving a station
Keeping the SKIP key pressed, press the MEMORY PRESET keys in
turn. The memorized frequencies appear on the display in turn,
while the station remains received. By releasing the keys, the fre¬
quency being received will be displayed. This is convenient for
deciding the MEMORY PRESET key to which the just received sta¬
tion is to be memorized.
HOW TO RECEIVE A MEMORIZED STATION
Turn on the receiver and press the MEMORY PRESET key.
The memorized frequency will be received.
HOW TO USE THE MEMO SHEET
Note the memorized frequencies on the supplied memo sheet and
stick it to the information piate. You can refer to it by sliding out the
plate.
The stations memorized to the MEMORY PRESET keys are scanned
from the a-1 key to d-8 key in sequence and scanning stops
automatically for 5 seconds or so when a signal is received. Only
the desired stations can be scanned by skipping the other memoriz¬
ed stations.
The numbers in the illustration refer to the sequence of operations.
1 Set the MAIN POWER switch and the POWER switch to ON.
2 Press the MEMORY SCAN START/STOP key.
The stations memorized to the a-1 key to the d-8 key will be scan¬
ned in sequence.
MEMORY SCAN
SCAN is displayed during
memory scanning. i
91?,5 u u
The station being received and
the MEMORY PRESET key number
are displayed.
When a signal is received, scanning will stop for 5 seconds and will
then resume.
To stop scanning, press the MEMORY SCAN START/STOP key.
TO SCAN STATIONS OF SOME KEYS OR OF A CERTAIN BAND
ONLY
Skip mark
When a MEMORY PRESET key is pressed initially, the f (skip) mark
is displayed with the number of the key. This mark means that the
key is skipped during memory scanning.
Skip mark
WIDE '
trnn
AM D UlU kHz
c-6
The skip mark initially appears with all the MEMORY PRESET keys.
It will be erased automatically once a station is memorized to the
key, so that the station can be located by memory scanning.
15