2
In the pull-down menu of the device selection section,
select [Local Disk] or [Removable Disk], and then
specify the directory.
3
Press [New].
4
Enter a name of up to eight characters, and press
[Enter].
Notes
•
The following names cannot be used.
Default, Flash1, Flash2
CON, PRN, AUX, CLOCK$, NUL
COM0, COM1, COM2, COM3, COM4, COM5,
COM6, COM7, COM8, COM9
LPT0, LPT1, LPT2, LPT3, LPT4, LPT5, LPT6,
LPT7, LPT8, LPT9
•
It is not possible to create 12 or more directories in
the frame memory folder.
To rename a frame memory folder
1
Select a folder.
2
Press [Rename].
3
Enter a name of up to eight characters, and press
[Enter].
To delete a frame memory folder
1
Select a folder.
2
Press [Delete].
3
Check the message, then press [Yes].
Saving the List of Frame Memory
Files to a Local Disk or Removable
Disk
If you save all files currently held in frame memory as a
single backup data set, by high-speed recording on video
tape or other medium, is created a file of file list data that
is needed for successful frame memory file restore
operation. It is necessary to save this file on a local disk or
removable disk.
1
Open the File >Frame Mem >File Name Data menu
(7153).
2
In the operating device selection section on the left or
right, select [Register].
The register name “FM_Bkup” appears. In the device
selection section on the opposite side, the destination
for saving automatically appears.
3
As the destination for saving select [Local Disk] or
[Removable Disk], then specify the directory.
4
Select the destination file for saving.
5
Carry out the following operation.
•
To save to disk, press [Save].
•
To load from disk, press [Load].
To view details of files
Press [File Edit].
A list of the saved file names appears. You can manipulate
these files like any other files.
File Batch Operations
You can batch process all files or registers.
Batch Saving Files
To save the data of all registers to a local disk or removable
disk, use the following procedure.
Notes
•
Files saved on a local disk may be lost if the local disk
fails. Always keep separate backup copies of important
files on a removable disk.
•
Format a removable disk before using it for the first time
(
1
p. 322).
•
You cannot perform the following operation when [Src
Patch Link] is lit on the menu screen
(
1
p. 379).
1
Open the File >All, External File >All menu (7161).
2
In the device selection area of the All menu, select the
destination for saving the files ([Local Disk] or
[Removable Disk] and directory).
3
If there are registers you do not want to save, in the
<Category> group, exclude them from the operation.
To select all registers, press [All Select]
(
1
“Files
that can be manipulated” (p. 302)).
Notes
The frame memory is not selected when you press [All
Select]. To apply the setting to frame memory, press
[Frame Memory], turning it on. When frame memory
To Next Page
Loading...
