Sony LBT-D109CD - Time-Based Programming; Designating Total Playing Time

Designating the Total Playing Time
You can designate a playing time and the unit will make two different programs of
selections each fitting within that period. Use this function, by designating the salah
of your tape, for editing both sides of a tape.
This feature, called Time Edit, sets the playing time of each program within the
designated time automatically by choosing selections in numerical order.
| You can also program desired selections by priority. In this case, you can designate
desired selections beforehand and the remaining selections will be programmed to fit
the remaining time.
3 Press the dq <4/ D> PPI (or led / PPI)
button.
[em00:
| =
a
eT
Eee
‘ q Each time you press the 44 44 />> PPI (or ied
3
|
<=
2
PPI)
button,
the
display
sa
to
give
you
the
———
:
following
duration.
23.- —-<——> 27.- - <> 90.- |
~-- *— > 45.- -< > 97.--
To designate the length of one side of your
tape by the numeric buttons.
Press [10 ]for 0 on the remote commander.
It is generally not necessary to press numeric
buttons for seconds.
|
To adjust the seconds
Keeping the l¢¢ << /P>> PPI button pressed
2 Press the EDIT button and display “EDIT”. changes the set time by 10 second intervals.
4 Press the EDIT button.
The selections for program A are determined
i
automatically.
Then
the
display
shows
the
last
selection to be recorded (a)), total playing time (6)),
|
and
the
selections
to
be
recorded
(c)).