Sony LT10 Series - 5-1-3. RS-232 C model

54
English
2. Setting the data signalling rate
is displayed and the data
signalling rate can be selected.
600, 1200, 2400, 4800, 9600,
19200 bps
3. Setting the data length
is displayed and the
data can be set to 7 or 8 bits.
4. Setting the stop-bit
is displayed and the
stop bit can be set to one or 2
bits.
5-1-3. RS-232C model
(only LT10-105C/205C, LT11-101C/201C)
Proceeds to the next setting mode from “5-1-1. Basic settings”
step 4.
1. Setting the output data format
: Normal output
1st byte : Channel name (A or B)
2nd byte : Sign (space: “+”, “–”)
3rd to 8th bytes : Numerical data (ex.12.345)
: Outputting with measurement mode information
1st byte : Channel name (A or B)
2nd byte : Current mode
( N : Current value,
P : Peak-to-peak value,
I : Minimum value,
A : Maximum value)
3rd byte : Unit (M: mm, I: inch)
4th byte : Sign (“+” or “–”)
5th to 10th bytes : Numerical data (ex.00.000)
: Outputting according to the mode 1 format
(statistical calculations) of the digital printer
P40 (P40 is sold separately).
Whether, with the 2 channel model, to output B channel data
following a space or to divide it with the delimiter is selected
by step 9. (except for P40 mode)
Note
When set to
mode even the
2 channel model only outputs the A
channel.
factory-set
factory-set
factory-set
factory-set