Chapter 5 Editing
Chapter 5 Editing 5-15
Notes
• In preread editing, if an input video signal is used as
the reference signal for the output video signal, this
forms a feedback loop. To prevent the occurrence of
feedback, set the OUTREF in function menu page 4
to REF, and set item 309 in the extended setup menu
to AUTO 1 so as to use an external reference signal.
•When the preread mode is selected, to prevent
feedback due to the loop connection, whatever the
editing mode of this unit, no E-E video output is
available.
When the PREREAD is set to OFF after preread
editing, however, if the loop connection remains and
an E-E signal is output, feedback will occur.
To prevent this, select PB mode for the video and
digital audio channels in all the modes before the
preread editing, as follows.
1 Set PB/EE in function menu HOME page to PB.
2 Set the PREREAD in function menu page 4 to ON.
3 Make the necessary connections for the preread
editing.
4 After selecting the desired insert editing mode,
carry out the preread editing.
5 When the preread editing is completed, remove the
connections.
6 Set the PREREAD to OFF.
7 Check that no loop connection remains.
Note
It is not possible to carry out a preread editing when
SDTI-CP input/output signal is selected.
To Next Page
Loading...
