Sony MVS-3000 System - Setting Multi Viewer Tally Output

27
Using Multi Viewer
Preparation
2 Assign an output signal to a subscreen.
Source/Output Assign menu
a In the <Source/Output Select> group, select
[Output].
b In the [Win#] column of the list on the left, select
the number of the subscreen.
In this example, select “1”.
c In the list on the right, select the signal you want to
assign.
In this example, select “P/P PVW”.
d Press [Set].
3 Assign an input signal to a subscreen.
Source/Output Assign menu
a In the <Source/Output Select> group, select
[Source].
b In the [Win#] column of the list on the left, select
the number of the subscreen.
In this example, select “3”.
c In the list on the right, select the signal you want to
assign.
In this example, select “CAM1”.
d Press [Set].
4 Repeat steps 2 and 3 as required to assign other signals
to other subscreens.
Setting Multi Viewer Tally Output
To display the tally on the multi viewer screen, you must
set the same tally type as specified in step 2 of “Setting
Serial Tally” (1 p. 28).
1 Display the menu.
a Open the Engineering Setup >Panel >Operation
menu (7326).
b Press [Button Tally].
The Button Tally menu (7326.9) appears.
2 Set the tally type.
Button Tally menu
a In the <Tally Type> group, select the tally type.
In this example, select [R1].
b Press [Execute].
To display a tally on the multi viewer screen, select the
tally type from [R1] to [R8]. If you set [Independ], the
tally is not shown.
When any of the red tally types [R1] to [R8] is
selected, the corresponding green tally is
automatically set. For example, when [R1] is selected,
[G1] is automatically set as green tally. Note that you
must set the tally type [G1] in step 2 of “Setting Serial
Tally” (1 p. 28) beforehand.
Set Output
Win#
Set Source
Win#
Notes
Tally Type Execute