39
Enabling Background DME Wipes (MVS-3000/3000A only) / Setting the Startup State
Preparation
Enabling Background
DME Wipes
(MVS-3000/3000A only)
On the MVS-3000 and on the MVS-3000A without an
MKS-6570 installed, only the background DME wipe or
key 1 can be enabled at any one time. The key 1 is enabled
by default, and you must change the setting to use the
background DME wipe.
This setting can be made for each of the M/E and PGM/
PST banks. This section describes the procedure for
enabling the DME wipe on the M/E-1 bank.
1
Display the menu.
a Open the Engineering Setup >Switcher >Config
menu (7331).
2
Enable the background DME wipe.
Config menu
a Select the target M/E or PGM/PST bank in the
[Bank] column.
In this example, select “M/E-1”.
b In the <BKGD DME Wipe/Key1> group, select
[BKGD DME Wipe].
To enable key 1, select [Key1].
For details about switching backgrounds using DME
wipes, see “Setting Picture-in-Picture (DME Wipe)”
(1 p. 50).
Setting the Startup State
Selecting the Startup Mode at Power
On
You can set the startup mode when power is turned on to
one of the following three options.
• Settings valid when power is last turned off
• User default settings
• Factory default settings
This setting is available for the switcher processor, control
panel, and DME.
1
Display the menu.
a Open the Engineering Setup >System >Start Up
menu (7314).
2
Select the device to set.
Start Up menu
a Select switcher processor (SWR), control panel
(PNL), or DME in the [Device] column.
3
Set the startup mode.
Settings valid when power is last turned off
a In the <Start Up Mode> group, select [Resume].
User default settings
a In the <Start Up Mode> group, select [Custom].
Memo
BKGD DME Wipe
Bank
Start Up Mode
Setup Initial Status Execute
Device
MVS-6520/6530/3000A screen shown.
On the MVS-3000, [DME1] is not displayed.
To Next Page
Loading...
