Sony MVS-3000 System - Assigning 8-Keyer Buttons (MVS-6530 Only); Assigning Key 5 to Key 8 to 1 St Row Buttons

37
Assigning 8-Keyer Buttons (MVS-6530 only)
Preparation
a) MVS-6530 only
b) MVS-6520/6530/3000A only
c) Virtual DME output signals for tally
Assigning 8-Keyer
Buttons
(MVS-6530 only)
On the MVS-6530 (3M/E processor), eight keyers can be
used in the PGM/PST banks. The buttons required for key
5 to 8 operation are not pre-assigned by default, and must
be assigned using the following procedure.
For details about operations using assigned buttons, refer
to the User’s Guide.
Assigning Key 5 to Key 8 to 1st Row
Buttons
You can make assignments so that key 5 to key 8 can be
selected using buttons in the 1st row of the cross-point
control block (1 p. 46).
1 Display the menu.
a Open the Engineering Setup >Panel >Operation
>Key/AUX/Function Assign menu (7326.13).
2 Select the target bank.
Key/AUX/Function Assign menu
a In the <Bank Select> group, select [P/P].
90 Frame Memory 6
91 Frame Memory 7
92 Frame Memory 8
93
94
95 DME Monitor Video
b)
96 DME Monitor Key
b)
97 M/E-1 Out 1
98 M/E-1 Out 2
99 M/E-1 Out 3
100 M/E-1 Out 4
101
102
103 M/E-2 Out 1
a)
104 M/E-2 Out 2
a)
105 M/E-2 Out 3
a)
106 M/E-2 Out 4
a)
107
108
109
110
111
112
113
114
115 P/P Out 1
116 P/P Out 2
117 P/P Out 3
118 P/P Out 4
119
120
121 DME 1
b) c)
122 DME 2
b) c)
123
124
125 DME 5
c)
126 DME 6
c)
127 DME 7
c)
128 DME 8
c)
Bit No. Source
Bank Select
Set
Button#