Sony MVS-3000 System - Page 49

49
Video Switching (Transitions)
Basic Image Creation Operations
5 Set the transition rate.
a In the Flexi Pad, press the [TRANS RATE] button.
b Press the [M/E1] button, turning it on.
c While viewing the alphanumeric display, enter the
transition rate you want to set.
In this example, enter “20” (frames).
d Press the [ENTR] button.
Flexi Pad
6 Execute the transition.
a Check the post-transition video on the preview
monitor.
b Operate the fader lever.
In this example, pull the lever from top to bottom.
Transition control block
The output comprises 50% each of both
background A video and background B video when
the fader lever is in the center position.
Mid transition state
When you press the [AUTO TRANS] button, the
transition is executed automatically according to the
set transition rate.
Alphanumeric display
TRANS RATE button
M/E1 button
MVS-6520/3000A diagram shown.
On the MVS-3000, the [DME1] and [DME2] buttons are not
displayed.
On the MVS-6530, the [M/E2] button is also displayed.
AUTO TRANS button
Transition rate
display
Fader lever
Memo
Background A
Background B