22
Note
Track marks may be copied incorrectly:
• when you record from some CD players or multi disc players using digital
(optical) input.
• when the source is in shuffle or program play mode while recording using
digital (optical) input. In this case, play the source in normal play mode.
• when recording BS or CS programs through digital (optical) input.
Recorded track
numbers
Marked (copied)
automatically
• at the same positions as
the source (when the
sound source is a CD or
an MD).
• after more than 2
seconds of blank or low-
level segment (with a
sound source other than
CD or MD).
• when the recorder is
paused during synchro-
recording (the recorder
pauses automatically
when it encounters a
section with no audio
signal for 3 seconds or
more).
You can erase
unnecessary marks after
recording. (“Erasing a
track mark”, page 44).
Marked automatically
• after more than 2
seconds of blank or
low-level segment.
• when the recorder is
paused while
recording.
You can erase
unnecessary marks
after recording
(“Erasing a track
mark”, page 44).
Recorded
sound level
Same as the source.
Can also be adjusted
manually (Digital REC
level control) (“Adjusting
the recording level
manually (Manual
recording)”, page 29).
Adjusted
automatically. Can
also be adjusted
manually (“Adjusting
the recording level
manually (Manual
recording)”, page 29).
Difference Digital (optical) input Analog (line) input
To Next Page
Loading...
Need help?
General
