41
Editing recorded tracks
You can edit your recordings by adding/erasing track marks or
labeling tracks and MDs. Premastered MDs cannot be edited.
Notes on editing
• Do not move or jog the recorder while “TOC Edit”* is flashing in the display.
• You cannot edit tracks on an MD that is record-protected. Before editing
tracks, close the tab on the side of the MD (page 54).
• If you perform an editing operation while playing, be sure not to turn the
power off until “TOC Edit” disappears in the display.
• The lid does not open until “TOC Edit” disappears in the display after
editing.
∗ TOC = Table of Contents
When you operate the recorder with the supplied remote control, use
the buttons and controls shown in parentheses.
Erasing tracks
To erase a track
Note that once a recording has been erased, you cannot retrieve it.
Make sure of the track you are erasing.
1 While playing the track you want to erase, press ENTER (EDIT
for 2 seconds or more).
ENTER
<MENU,
T MARK
ENTER
EDIT
>/.
T MARK
continued
To Next Page
Loading...
Need help?
General
