Sony PS-FL1 - Gear Block and Motor Details; Gear and Motor Identification Notes

GEAR BLOCK
gear block
EACH GEAR, MOTOR
E3 ®
plastic
washer
4mm
dia
|
worm wheel {A}
plastic washer 4mm dia. a eg
E3 &
plastic washer 5mm dia. ——-~-@Q
E26)
plastic washer 3mm dia. ——<¢y
midway gear (C) =
23.5mm dia. E3@
plastic washer 4mm dia. gb
worm wheel (B}
3imm dia.
midway gear (B) cemeeer <5)
16.5mm dia.
© £2 midway gear (A)
| 28.5mm dia.
eS)
“|
ij it .
plastic washer 4mm dia.
motor for module
slide (M102)
motor for
tonearm (M101)
The motors can be identified
by the hole on the end.
M101: no hole
M102: hole
PS-FL1/FL1C
BVTP3x8
26mm dia.
Lge switch board
plastic washer 3mm dia.
GQ E3
(a plastic washer 4mm dia.
driving gear
plastic washer
4mm dia.
eat
B3 x 20
rack guide
Note: Refer to the maximum diameter for each gear when mounting.
Module slide system: M102—»worm wheel (A)—driving gear
Tonearm system: M101—»worm wheel (B)—»midway gear (C) >
midway gear (B)-» midway gear (A)-»tonearm
The gear angles do not need to be aligned, but the gears must engage.