Sony RCD-W3 User Manual

10
Locating a Specific Track
You can quickly locate any track while playing
a disc by using the AMS . and >
(Automatic Music Sensor) on the deck, .
and > buttons on the remote, or number
buttons on the remote.
Before using the remote, set SELECT to CD for
operations on DECK A, or to CDR for
operations on DECK B.
AMS ./>
To locate
Stop playback
The next or
succeeding
tracks
The beginning
of the current or
preceding tracks
A specific track
directly
* AMS: Automatic Music Sensor
Tips
To pause playing at the beginning of a track, press
AMS . or > (or press . or > on the
remote) after pausing playback.
Do the following:
Press x.
During playback, press AMS* >
until you find the track.
During playback, press AMS .
until you find the track.
Press the number button(s) on the
remote to enter the track number.
Playing directly using the
number buttons
You can playback a track directly by using the
number buttons. Press the track number you
want to play. The track will be played shortly
after you press the number buttons. If the
number is 2 digits, press the second digit
immediately after you press the first digit.
Example:
When you press 1 (or 2 ,etc.), “1--” appears on
the front panel display.
If you don’t press the second digit immediately,
track 1 will be played shortly after “1--”
appears on the front panel display.

Sony RCD-W3 Specifications

Power

power requirements	U.S.A. and Canada 120 V AC, 60 Hz
power requirements other countries	110 – 240 V AC, 50/60 Hz
power consumption	20 W

Audio Specifications

frequency response	20 Hz – 20, 000 Hz (±0.5 dB)
signal-to-noise ratio	More than 100 dB
dynamic range	More than 95 dB

Inputs

analog in impedance	47 kilohms
rated input	330 mVrms
minimum input	125 mVrms

Outputs

analog out rated output	2 Vrms (at 50 kilohms)
load impedance	over 10 kilohms
phones	28 mW, 32 ohms

Weight and Dimensions

dimensions	430 × 108 × 368 mm
mass	4.6 kg