Sony RCD-W3 User Manual

9
Basic Operations
The TOC indicator
When you put an unfinalized CD-R disc or CD-
RW disc in the disc tray, the TOC indicator
lights up.
For details on finalizing, refer to page 19, and page
20 for unfinalizing.
Note
When you put a CD or finalized CD-R disc in a disc
tray, the CD indicator lights up as “CD.”
The total track number and total playing time are
displayed
The total track number and the remaining
recordable time are displayed
Checking the remaining
recordable time
When you placed an unfinalized CD-R or CD-
RW in the DECK B, you can also check the
remaining recordable time. The information
appears as follows:
Before using the remote, set SELECT to CDR
for operations on DECK B.
Each time you press TIME, the front panel
display is change as below.
On the TOC and CD-R/RW
indicator
The CD-R/RW indicator shows which type of
recordable disc is in DECK B, and whether the
recordable disc has been already finalized.
The CD-R/RW indicator
The TOC
indicator
The CD-R/RW indicator
When you put an unfinalized CD-R disc in the
disc tray, the CD-R/RW indicator lights up as
“CD-R.”
When you put a CD-RW disc in the disc tray,
the CD-R/RW indicator lights up “CD-RW,”
and it does not matter if the disc has not been
finalized.

Sony RCD-W3 Specifications

Power

power requirements	U.S.A. and Canada 120 V AC, 60 Hz
power requirements other countries	110 – 240 V AC, 50/60 Hz
power consumption	20 W

Audio Specifications

frequency response	20 Hz – 20, 000 Hz (±0.5 dB)
signal-to-noise ratio	More than 100 dB
dynamic range	More than 95 dB

Inputs

analog in impedance	47 kilohms
rated input	330 mVrms
minimum input	125 mVrms

Outputs

analog out rated output	2 Vrms (at 50 kilohms)
load impedance	over 10 kilohms
phones	28 mW, 32 ohms

Weight and Dimensions

dimensions	430 × 108 × 368 mm
mass	4.6 kg