Sony SA-WCT770 - SUB AMP BLOCK

SA-WCT770
8
2-5. SUB AMP BLOCK
2-4. SUB LED BOARD
2 two screws
(BVTP2.6)
1 LED cover
3 SUB LED board
3DVWLQJSRVLWLRQRI/('FRYHU
–7RSSDQHOEORFNERWWRPYLHZ–
OK
NG
guide line
LED cover SUB LED board
LED cover SUB LED board
front edge of the top panel
front edge of the top panel
LED cover is over the front edge of the top panel.
OK NG
1 tapping screw
(3.5 u 14)
1 two tapping screws
(3.5 u 14)
3 speaker connector
(CN109)
4 sub AMP block
1 tapping screw
(3.5 u 14)
2 Lift the sub AMP block
in the direction of an arrow.
– Rear view –
sub AMP blockscrew hole
Speaker wire is front side.
Speaker wire is rear side.
sub AMP block
screw hole
 :ire VeWWiQJ