Sony SLV-E170EE - Page 25

SLV-E170EE/E170EG/E320EE/E470EE/E470EG
THIS NOTE IS COMMON FOR PRINTED WIRING
BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is
printed in each block.)
12 13 14 15 16 17
¢ For printed wiring boards.
¢ === -: Pattern from the side which enables seeing.
Caution :
Pattern face side: Parts on the pattern face side
(Conductor Side) seen from the pattern face are
indicated.
Pattern face side: parts on the parts face side seen
(Component Side) from the parts face are indicated.
For schematic diagrams.
Caution when replacing chip parts.
E170 MODEL New parts must be attached after removal of chip.
Be careful not to heat the minus side of tantalum
capacitor, because it is damaged by the heat.
All resistor are in ohms, 1/4W unless otherwise noted.
Chip resistor are 1/10W unless otherwise noted.
kQ: 1000Q, MQ, : 1000kQ.
H
¢
All
capacitors
are
in
uF
unless
otherwise
noted.
pF
:
u
uF. 50V or less are not indicated except for electrolytics
and tantalums.
CNVS40.
| falweo J
1 feof vioco wn |
[sof vroeo oot | fe
pet ase —__ oP * [-_]: panel designation.
i
———
ae)
*
A:
internal
component.
i
face
|
26
*
mmm
>
B+Line.
*
a
5°
e
mmm
:B+Line.
*
:
i fofe 6° | [Ener } ¢ 2 :\N/OUT direction of (+,-) B LINE. *
ee
———
a)
}
¢
Circled
numbers
refer
to
waveforms.
*
epee
ee
i
*
Readings
are
taken
with
a
color-bar
signal
input.
i t [efwcam | 5° ¢ Voltage are dc between ground and measurement
f= — ||60 | point." Ee dae.
i Afar ° ¢ Rradings are taken with a dijital multimeter (DC10MQ).*
epee ¢ Voltage variations may be noted due to normal production
aia (BS ca a . tolerances.*
SP CHe
aos sees seen 64 ese,
EP CHI
When indicating parts by reference number, please
include the board name.
EP CHa: e *: indicated by the color red.
£470 MODEL
SP CHI:
FOR CHECK
AC IN
4-2
4-3
FRAME
SCHEMATIC
DIAGRAM