6-1 E
SECTION 6
ERROR CODES
SLV-ED8/EZ8/EZ9
This set displays an error code, and a mode code in case of error
on the display tube, if the operation stopped by error.
The following provides description concerned.
A: EMG code .............................................................. Table 6-1
B: Mechanism position (Encoder) .............................. Table 6-2
These codes are displayed at lower 5-digit positions of display
tube.
Table 6-1. EMG Codes list
Table 6-2. Mechanism position list
Code Description
0 NO ERROR
1 CAM ENCODER ERROR, LOAD DIRECTION
2 CAM ENCODER ERROR, UNLOAD DIRECTION
3 T REEL ERROR
4 S REEL ERROR
5 CAPSTAN ERROR
6 DRUM ERROR
7 INITIALIZE ERROR
8 CASSETTE UNLOADING ERROR
9 RESERVED
Code Position VTR status
0 NC Other than the following positions
1 EJECT EJECT (including POWER OFF)
2 CDOWN Cassette at down position
3 ULDEND Tape unloading end, DEW STOP
4 TLOAD Tape loading
5 HCLEAN Tape loading
6 LDEND Tape loading end
7RVS
RVS varying-speed play
(including STILL, SLOW)
8 PR For FWD, FWDP/RVS conversion
9 FWDP FWD SLOW, FWD STILL
A FWD
PB, FWD varying-speed play, STOP
(DRUM ON)
B STOP STOP (DRUM OFF, POWER OFF)
C FR FF/REW
If the cam encoder alarm occurred when the mechanism was about
to move forward, and it stopped at NC position,
Position for which mechanism destined= A (FWD)
Position when emergency occurred = 0 (NC),
accordingly, “A0” is displayed.
In case of emergency except cam encoder alarm or FL cassette
compartment alarm, the cam motor does not run, and therefore if
any emergency occurred at FWD position,
Position for which mechanism destined= A (FWD)
Position when emergency occurred = A (FWD),
accordingly, “AA” is displayed.
* NC code is output when the mechanism is moving between re-
spective positions.
Display tube (lower 5 digits)
AB
Position when emergency occurred
Position for which the mechanism destined
Display:
To Next Page
