36
GB
Note
Character or marks may not be displayed for some
languages.
Recording using the
receiver
You can record from an audio/video
equipment using the receiver. Refer to the
operating instructions supplied with your
recording equipment.
1 Prepare the source for playing.
Press the input button to select the source.
You can also use INPUT SELECTOR on
the receiver.
Example 1 (audio recording):
Press SA-CD/CD.
Example 2 (video recording
– HT-M7/
HT-M5 only):
Press SAT/CATV.
2 Prepare the recording
equipment.
Insert a blank video tape, etc. into the
recording equipment (connected to
VIDEO OUT jacks).
3 Start recording on the
recording equipment, then start
the playback equipment.
Notes
•Some sources contain copyright protection to
prevent recording. In this case, you may not be able
to record from the source.
•While the source is being recorded, the auto
standby function of the receiver may start up and
interrupt the recording. In this case, set the
“AUTO.STBY” to “STBY OFF” (page 52).
•(HT-M7/HT-M5 only)
Audio input signals via HDMI IN, DIGITAL IN
and COMPONENT VIDEO IN jacks cannot be
recorded.
•(HT-M3 only)
–You can only record audio signals using this
receiver.
–Audio input signals via HDMI IN and DIGITAL
IN jacks cannot be recorded.
To Next Page
Loading...
Need help?
General
