37
GB
Tuner Operations
Listening to FM/AM radio
You can listen to FM and AM broadcasts
through the built-in tuner. Before operation,
make sure you have connected the FM and
AM antennas (aerials) to the receiver (page
28).
Tip
The tuning scale for direct tuning is shown below.
*The AM tuning scale can be changed (page 38).
1)
RM-AAU135 only.
2)
RM-AAU136 only.
1 Press TUNER repeatedly (or
press FM or AM) to select the
FM or AM band.
You can also use INPUT SELECTOR on
the receiver.
2 Press TUNING + or TUNING –.
TUNING + scans from lower to higher
frequency stations and TUNING – for
scanning higher to lower.
The receiver stops scanning whenever a
station is received.
In case of poor FM stereo
reception
If the FM stereo reception is poor and “ST”
flashes on the display panel, select monaural
audio to lessen the sound distortion.
Press FM MODE repeatedly to select
“MONO”.
To return to stereo mode, press FM MODE
repeatedly to select “STEREO”.
You can enter the frequency of a station
directly by using the numeric buttons.
1 Press TUNER repeatedly (or
press FM or AM) to select the
FM or AM band.
You can also use INPUT SELECTOR on
the receiver.
2 Press D.TUNING.
Tuner Operations
Area FM AM
Latin America,
Argentina and Mexico
50 kHz 10 kHz
*
Australia, South Africa,
Middle East, India and
Thailand
50 kHz 9 kHz
TUNING
+/–
ENTER
Numeric
buttons
D.TUNING
AMP
MENU
,
V/v/B/b
AM
2)
FM MODE
TUNER
1)
/
FM
2)
Tuning to a station
automatically (Automatic
Tuning)
Tuning to a station directly
(Direct Tuning)
continued
To Next Page
Loading...
Need help?
General
