• CNT SPK (Center speaker)
•
NO
If you have not connected a center speaker,
select
"NO".
The sound
of
the center
channel will be output from the front
speakers.
•
SMALL
Ifthe sound is distorted,
or
you feel a lack
of
surround effects when using multi channel
surround sound, select
"SMALL"
to activate
the bass redirection circuitry and output the
center channel bass frequencies from the
front speakers (if set to
"LARGE")
or
subwoofer.
•
LARGE
If you connect a large speaker that will
effectively reproduce bass frequencies,
select
"LARGE".
Normally, select
"LARGE". However,
if
the front speakers
are set to
"SMALL",
you cannot set the
center speaker to
"LARGE".
• SUR SPK (Surround speakers)
The surround back speakers will be set to the
same setting.
•
NO
If
you have not connected surround
speakers, select "NO".
•
SMALL
If
the sound is distorted,
or
you feel a lack
of
surround effects when using multi channel
surround sound, select
"SMALL"
to activate
the bass redirection circuitry and output the
surround channel bass frequencies from the
subwoofer
or
other
"LARGE"
speakers.
• LARGE
If
you connect large speakers that will
effectively reproduce bass frequencies,
select "LARGE". Normally, select
"LARGE". However,
if
the front speakers
are set to "SMALL", you cannot set the
surround speakers to "LARGE".
52
US
•
S8
SPK (Surround back
speakers)
When the surround speakers are set to
"NO",
the surround back speakers are also
automatically set to
"NO"
and the setting
cannot be changed.
• NO
If
you have not connected a surround back
speaker, select "NO".
• SINGLE
If
you connect only one surround back
speaker, select "SINGLE". The sound will
be output to a maximum
of
6.1 channel.
• DUAL
If
you connect two surround back speakers,
select "DUAL".
The
sound will be output to
a maximum
of
7.1
channel.
Tip
The "LARGE" and "SMALL" settings for each
speaker determine whether the internal sound
processor will cut the bass signal from that channel.
When the bass is cut from a channel, the bass
redirection circuitry sends the corresponding bass
frequencies to the subwoofer
or
other "LARGE"
speakers.
However, since bass sounds have a certain amount
of
directionality, it
is
best not to cut them, if
possible. Therefore, even when using small
speakers, you can set them to "LARGE"
if
you want
to output the bass frequencies from that speaker. On
the other hand,
if
you are using a large speaker, but
prefer not to have bass frequencies output from that
speaker, set it to "SMALL".
If the overall sound level is lower than you prefer,
set all speakers
to
"LARGE". If there
is
not enough
bass, you can use the equalizer to boost the bass
levels. For details, see page 41.
To Next Page
Loading...
