Using
the
Remote
Changing
button
assignments
You can
change
the factory settings
of
the
input buttons to suit the components in your
system.
For
example, if you
connect
a
DVD
recorder to the
VIDEO
I
jacks
on
the receiver,
you
can
set the
VIDEO
I button
on
this remote
to control the
DVD
recorder.
Note
You cannot change the settings
of
OMPORT and
TUNER buttons.
Categories and the
corresponding buttons
Categories Press
VCR
(command
mode
VTR
3)a) I
VCR
(command mode
VTR
2)a) 2
DVD player/DVD recorder 3
(command mode DVDI)b)
DVD recorder 4
(command mode DVD3)b)
CD
player 5
Euro Digital Satellite Receiver 6
DVR
(Digital CATV terminal) 7
DSS (Digital Satellite Receiver) 8
Blu-ray disc player 9
(command mode BDI)c)
a)
Sony VCRs are operated with a VTR 2 or VTR 3
setting which corresponds to 8 mm and VHS
respectively.
b)Sony OVO recorders are operated with a
OVDl
or
DVD3 setting. For details, refer to the operating
instructions supplied with the OVD recorders.
c)For details on the
SO
lor
S03
setting, refer
to
the
operating instructions supplied with the Slu-ray
disc player or Blu-ray disc recorder.
1 Hold down the input button of
which you want to change the
assignment.
Example: Hold
down
VIDEO
I.
2 Referring to the table below,
press the corresponding
button for the category you
want.
Example: Press 4.
Now
you
can use the
VIDEO
1 button to
control the
DVD
recorder.
Blu-ray disc recorder
(command mode
BD3t)
TV
0/10
.1>101
CLEAR
96
US
To clear all remote button
assignments
While holding
down
MASTER
VOL
-,
press
1/(9
and
DMPORT.
The
remote is reset to its factory settings.
To Next Page
Loading...
