65
GB
S-AIR Operations
3 Press V/v repeatedly to select
“<S-AIR>”, then press or b.
4 Press V/v repeatedly to select
“S-AIR MODE”, then press
or b.
5 Press V/v repeatedly to select
the setting you want.
• PARTY: The S-AIR receiver outputs
sound according to the input selected on
the S-AIR main unit.
• SEPARATE: You can select the input
you want for the S-AIR receiver while
the input of the S-AIR main unit remain
unchanged. When “SEPARATE” is
selected, you can only select “SA-CD/
CD”, “DMPORT”, “FM TUNER”,
“AM TUNER” and the input that is
currently selected on the S-AIR main
unit.
Note
When “FM TUNER” or “AM TUNER” is
selected on the S-AIR main unit, you can only
select the same band for the tuner on the S-AIR
receiver. However, you can select input other
than TUNER on the S-AIR receiver.
6 Adjust the volume on the
S-AIR receiver.
Notes
• The sound of the S-AIR receiver may be cut off by
operation of the S-AIR main unit.
• When the sound is other than 2 channel stereo,
multi channel sound is downmixed to 2 channel.
• Signals with a sampling frequency of more than
96 kHz cannot output to the S-AIR receiver.
To control the system from the
S-AIR receiver
You can control the system from the S-AIR
receiver by using the following buttons.
For details, refer to the operating instructions
of the S-AIR receiver.
Press Operation
N, X, x,
./>
Share the same operations on the
remote.
S-AIR CH Change the function of the
system.
To Next Page
Loading...
