Sony STR-DN610 - Using the setting menu

58
GB
D:\NORM'S JOB\SONY HA\SO0086\STR-DN610_PMRF 2\GB\GB08ADV_STR-DN610-U2.fm masterpage: Left
STR-DN610
4-167-824-13(1)
Notes
• Set “SB ASGN” to “BI-AMP” before you perform
Auto Calibration.
• If you set “SB ASGN” to “BI-AMP”, the speaker
level and distance settings of the surround back
speakers become invalid, and those of the front
speakers are used.
• If you set “PATTERN” to a setting with surround
back speakers, you cannot set “SB ASGN” to
“BI-AMP”.
Using the setting menu
By using the amplifier menus, you can make
various adjustments to customize the receiver.
1 Press AMP MENU.
2 Press V/v repeatedly to select
the menu you want, then press
or b.
3 Press V/v repeatedly to select
the parameter you want to
adjust, then press or b.
4 Press V/v repeatedly to select
the setting you want.
The setting is entered automatically.
To return to the previous
display
Press B or RETURN/EXIT O.
To exit the menu
Press AMP MENU.
Note
Some parameters and settings may appear dimmed
on the display. This means that they are either
unavailable or fixed and unchangeable.
MENU
O
AMP
MENU
RETURN/
EXIT O
,
V/v/B/b