Sony STR-V220 - Recording

:
r
;
:
Receiver Operations
— ——~s
Tuning preset stations (preset tuning)
You can tune directly to a preset station by entering its
preset number. If you don’t know which stations are
preset on which numbers, you can tune by scanning
the preset stations.
1 Press TUNER.
The last received station is tuned in.
2 Press SHIFT to select a memory page (A, B or C),
then press the number.
For example, select A and then press 7 to tune in
the station preset as A7.
SSS era ee]
Recording
This receiver makes it easy to record to and from the
components connected to the receiver. You don’t have
to connect playback and recording components
directly: once you select a program source on the
receiver, you can record and edit as you normally
would using the controls on each component.
Before you begin, make sure you've connected all
components properly.
Function buttons
Recording component
(tape deck, MD deck,
VCR)
Playback component
(program source)
= =: Audio signal flow
Recording on an audio tape or MiniDisc
You can record on a cassette tape or MiniDisc using the
' receiver. Sée the instruction manual of your tape deck
or MD deck if you need help.
1 Press one of the function buttons to select the
component to be recorded.
2 Set the component to be ready for playing.
For example, insert a CD into the CD player.
3 Insert a blank tape or an MD into the recording
deck and adjust the recording level, if necessary.
4 Start recording on the recording deck and then
start playing the component.
Note
Sound adjustments do not affect the signal output from the
TAPE/MD REC OUT jacks.
13