Sony STR-V220 - Specifications

Pe ee Pe in fee easy Mey inet h tut Ae Ga eee eh AN moe Opt gh Ye Ae OOS Sage, hn eee kee ee a ee a ee ae ee gk ge dg ek Re Mi ee ee ee ee a Re ee a ee Gg Le ge eae ne Ee LENE BAe Nee ET en GRE ge Pe eT ig NS See at Eh Ee Fe REE Re! ROS Aw PCO aE gee PST eee WGN RSE Bg Shea E eee Mp ee een ip Ce ha ee
18
yVololhaleysr- Miarielatir-heieye)
Ex, 7 ae eee
Specifications
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION
With 8 ohm loads, both
channels driven, from 20 -
20,000 Hz; rated 60 watts
per channel minimum RMS
power, with no more than
0.3% total harmonic
distortion from 250
milliwatts to rated output.
Amplifier section
POWER OUTPUT
Stereo mode (8 ohms 20 Hz - 20 kHz,
THD 0.3%)
60 W + 60 W
Surround mode (8 ohms at 1 kHz, THD
0.08%)
Front: 60 W/ch
Center*: 60 W
Rear*: 60 W/ch
* Depending on the
surround mode and the
source, sound will not be
output.
Frequency response
CD, TAPE/MD, TV/SAT,
VIDEO:
10 Hz - 50 kHz +1 dB
Inputs
Sensitivity Impedance S/N
(weighting
network,
input level)
cD
200 mV 82 dB
TAPE/MD, 150mV 50 kilohms (A, 150
TVISAT,
VIDEO se
Outputs TAPE/MD REC OUT:
Voltage: 150 mV,
Impedance: 10 kilohms
VIDEO AUDIO OUT:
Voltage: 150 mV,
Impedance: 10 kilohms
MIX AUDIO OUT:
Voltage: 2 V
Impedance: 10 kilohms
PHONES:
Accepts low and high
impedance headphones
MUTING Full mute
BASS BOOST +10 dBat 70 Hz
TONE +8 dB at 100 Hz and 10 kHz
FM tuner section
Tuning range 87.5 - 108.0 MHz ,
Antenna terminals
300 ohms, balanced
75 ohms, unbalanced
Sensitivity Mono: 18.3 dBf, 4.5 pV
Stereo: 38.3 dBf, 45 nV
Usable sensitivity
11.2 dBf, 2 pV (IHF)
S/N Mono: 76 dB
Stereo: 70 dB
‘Harmonic distortion at 1 kHz
Mono: 0.3%
Stereo: 0.5%
Separation 45 dB at 1 kHz
Frequency response
30 Hz - 15 kHz “2° dB
Selectivity 60 dB at 400 kHz
AM tuner section
Tuning range § With 10 kHz interval: 530 -
1710 kHz**
Antenna Loop antenna
Usable sensitivity
50 dB/m (at 1,000 kHz)
SIN 54 dB (at 50 mV/m)
Harmonic distortion
0.5% (50 mV /m,
400 Hz)
Selectivity At 10 kHz: 40 dB
* You can change the AM tuning
interval to 9 kHz or to 10 kHz. After
tuning in any AM station, turn off
the receiver. Hold down the
TUNING + button and press the 1/(
button. All preset stations will be
erased when you change the
interval. To reset the interval to 10
kHz, repeat the procedure.
General
Power requirements
120 V AC, 60 Hz
Power consumption
130 W
AC outlets 1 switched, 120 W/1 A
maximum
Dimensions 355 x 120 x 325 mm
(14 x 43/4 x 12 3/4 inches)
including projecting parts
and controls
Mass (Approx.)
5.7 kg (12 Ib 10 oz)
Supplied accessories
See page 4.
Design and specifications are subject to
change without notice.