Sony TC-K511S - Basic Playback Procedure

DOLBY NA
OFF
6 .B
Où
Playing Back
Follow the procedure below to play back a
cassette.
1 Turn on the amplifier and select the
tape function.
2 Insert the cassette with the side to be
played facing outward.
3 Set DOLBY NR to the same position
that was used when the cassette was
recorded.
4 Press PLAY to start playback.
To stop playback, press the M button.
To stop playback momentarily, press the
lH button.
To restart playback, press the Bi or B>
button.
To fastwind a tape rightward, press the
PP button in stop mode.
To fastwind the tape leftward, press the
44 button in stop mode.
Is it necessary to set the tape type
being used?
No. The deck has an automatic tape type
detection system.
What is the Dolby NR system?
The Dolby NR (noise reduction) system
reduces tape hiss noise in low-level, high-
frequency signals by boosting the signals
during recording and lowering them during
playback.
The Dolby S NR (TC-K511S only) system
provides the highest reduction in tape hiss
noise in both low and high frequencies.
Note
The Dolby HX PRO system is effective only
during recording, not during playback.