Sony TC-K611S - Chapter 4 Other Operation; Timer-Activated Playback and Recording

Inserting a
atcrereleellare]
pace During
— Record Muting
The Record Muting function allows you to insert a four-
second blank to enable proper Multi-AMS operation (see
page 8), and to replace unwanted input with a blank of any
desired length.
1 While recording, press O and release it
immediately.
REC MUTE
Ny
~ _
— {| REC | —
-” ~™
44»
The REC indicator starts flashing. During this
time, no incoming signals are recorded on the
tape.
After four seconds, the El indicator lights up and
the unit enters recording pause mode.
2 Press Il to resume recording.
PAUSE
[*]
To create a blank longer than four seconds
Press the O button for the desired length of time. After four
seconds, the REC indicator flashes with greater rapidity.
When you release the O button, the Ul indicator lights up and
the unit goes into recording pause mode.
Press the &f button to resume recording.
16
Chapter 4 Other Operation g
Timer-Activated Playback and
s{cYerelaoilate]
By connecting an optional timer, recording or playback can
be performed automatically at a preset time.
4 to a switched outlet
Timer
we to a wall outlet
1 Prepare the unit for playback or recording.
For playback Follow steps 1 through 3 on page
7.
Follow steps 1 through 6 on page
For recording 1
After comptleting the preparations, press ll to
change the unit to stop mode.
Make sure to close the holder completely.
2 Set the timer to the desired time.
Power to the tape deck will be cut off.
3 Set TIMER to PLAY or REC.
Playback or recording will start at the preset time.
Keep the POWER switch on the unit on
When the timer is set, the power to the unit will be cut off.
However, the POWER switch must be on to start timer-
activated operation.
When the timer-activated operation is completed
Set the TIMER switch on the unit to OFF. If the TIMER
switch is left at REC, the unit will automatically start
recording the next time the power is turned on, and the
previously recorded material may be erased.