To Next PageTo Next PageWhat to do if my Sony Printer says out of paper but there is still paper?
This is not a defect. Some spare paper will be left over. Remove the leftover paper and load a new ribbon cartridge and paper roll.
Why can't my Sony UP-CR10L read the image data?
There are several reasons why your printer might not be able to read image data: * The memory card may not contain any data, so insert a memory card that contains image data. * Data has been recorded on the memory card in a format that the unit does not recognize. Be sure to store image data in a format that the unit can recognize. * The memory card may not be properly inserted. Make sure that the memory card is fully inserted. * The memory card may not be inserted in the correct direction. Set the memory card in the direction shown on the operation screen.
Why is there a white margin on my Sony UP-CR10L's printed image?
The print position may not be correct. Adjust the print position.
Why is the display not on or difficult to see on my Sony UP-CR10L Printer?
Depending on the display angle, the display may not be visible or may be difficult to see. Adjust the angle of the display to improve the display appearance.
What to do if my Sony UP-CR10L says “no ribbon cartridge” message appears after loading?
The ribbon may not have been loaded correctly. Ensure that ribbon is loaded correctly.
What to do if my Sony Printer says “no paper” message appears after paper roll was loaded?
The paper roll may not have been loaded correctly. Ensure that paper roll is loaded correctly.
Why won't my Sony UP-CR10L power on?
If your Sony Printer isn't powering on, ensure the power cord is securely connected. Also, verify that you've fully pressed the on/standby button.
How to fix Sony Printer when image data cannot be read?
If your Sony Printer can't read image data, it might be due to several reasons. First, the memory card might not contain any data. If it does, ensure the data is in a format the printer recognizes. Also, check that the memory card is fully and correctly inserted into the printer, following the direction indicated on the operation screen.
What to do if my Sony Printer says 'no paper' after loading paper?
If your Sony Printer displays a 'no paper' message even after loading the paper roll, ensure that the paper roll is loaded correctly.
Why does my Sony UP-CR10L not switch to standby mode?
If your Sony Printer doesn't switch to standby, it may still be processing data; wait for it to finish. If the issue persists, disconnect the power cord from the outlet, reconnect it, and then press the on/standby button.
General| Print Resolution | 300 dpi |
|---|---|
| Print Technology | Dye-sublimation |
| Connectivity | USB |
| Print Method | Dye-sublimation |
| Interface | USB |
