Sony VPL-CX63 - Page 25

21
VPL-CX61/CX63/CX75/CX76/CX80/CX85/CX86/CX100/CX120/CX125/CX150/CX155/CW125/FE40/FE40L/FH300L/FX40/FX40L/FX51/FX52/FX52L/FW300L/PX35/PX40/PX41
2 [Power status inquiry] POWR?
This command obtains the projector’s power status.
The projector responds as follows:
Returns the following values when the power status is obtained:
Standby or power-saving state : Returns “0”.
Power ON state : Returns “1”.
Cooling state, or cooling state during power-saving state :Returns “2”.
Startup state : Returns “3”.
Projector error occurring (including warning) : Returns “ERR4”.
3. [Input switch command] INPT
This command switches the projector’s inputs.
The available parameters are as follows: (The input channel varies depending on the model.)
Parameter 21 : Projector input Video
Parameter 22 : Projector input S-Video
Parameter 31 : Projector input Input A
Parameter 32 : Projector input Input B
Parameter 33 : Projector input Input C
Parameter 34 : Projector input Input D
Parameter 35 : Projector input Input E
Parameter 36 : Projector input Input F
Parameter 51 : Projector input Network
The projector responds as follows:
When processed properly : Returns “OK”.
When inexistent input is specified : Returns “ERR2”.
Unacceptable period (when the power status is other than Power ON) : Returns “ERR3”.
Projector error occurring (including warning) : Returns “ERR4”.
4. [Input switch inquiry] INPT?
This command obtains the projector’s input status.
The projector responds as follows:
Returns the following values when the input status is obtained:
When the projector input is Video : Returns “21”.
When the projector input is S-Video : Returns “22”.
When the projector input is Input A : Returns “31” .
When the projector input is Input B : Returns “32”.
When the projector input is Input C : Returns “33”.
When the projector input is Input D : Returns “34”.
When the projector input is Input E : Returns “35”.
When the projector input is Input F : Returns “36”.
When the projector input is Network : Returns “51”.
Unacceptable period (when the power status is other than Power ON) : Returns “ERR3”.
Projector error occurring (including warning) : Returns “ERR4”.