19
Turning Off the Power
Projecting the Picture
Turning Off the
Power
1 Press the ?/1 key.
“POWER OFF? Please press ?/1 key
again.” appears to confirm that you want
to turn off the power.
The message disappears if you press any
key other than the ?/1 key, or if you do not
press any key for five seconds.
2 Press the ?/1 key again.
The lens protector closes and the
powered tilt adjuster is retracted into the
projector. The ON/STANDBY indicator
flashes in green and the fan continues to
run for about 60 seconds to reduce the
internal heat. Also, the ON/STANDBY
indicator flashes quickly for the first 45
seconds. During this time, you will not
be able to light up the ON/STANDBY
indicator again with the ?/1 key.
3 Unplug the AC power cord from the
wall outlet after the fan stops running
and the ON/STANDBY indicator
lights in red.
When you cannot confirm the on-
screen message
When you cannot confirm the on-screen
message under certain conditions, you can
turn off the power by holding the ?/1 key for
about two seconds instead of following steps
1 and 2.
The internal circuitry of the Off & Go and
Direct Power On/Off functions may cause the
fan to continue to operate for a short time even
after the ?/1 key is pressed to turn off the
power and the ON/STANDBY indicator
changes to red.
Note
Note
To Next Page
Loading...
