1-7 (E)
VPL-EX100
2
Lamp duct
3
Three hooks
4
Upper lamp duct
6
DC fan
n
When attaching, place the label
side facing upward.
5
Fuse connector
assembly
7
Lower lamp duct
1
Two screws
(BVTP3
x
10)
Label side
*
The illustration indicates VPL-EX120.
1-3-5. DC Fan (Lamp Duct)
. Remove the upper case assembly. (Refer to Section 1-3-1.)
. Remove the rear panel. (Refer to Section 1-3-2.)
. Remove the main board. (Refer to Section 1-3-3.)
. Remove the G board. (Refer to Section 1-3-4.)
To Next Page
